I. Too High Casting Temperature will Greatly Increase its Rejection Rate.
Too high casting temperature will make sand moulds inflate, especially for theses gray with complicated sand cores. When the casting temperature reaches ≥1420℃， corresponding rejection rate will begin to increase. And when the temperature is up to 1460℃, the rate will access to 50%. During the manufacture, adopting electric induction furnace melt can better keep corresponding casting temperature.
II. Low Casting Temperature is Likely to Form.
i. Manganese Sulfide Gas Holes
This kind of gas holes generally form on the upper place beneath the surface of grayand exposed after the machining process. Their diameters reach 2-6mm. Sometimes, a small number of molten slags can be seen in these gas holes.
ii. Gas Holes Resulting from Core Gas
Porosities and gas holes defects come from poor exhausts from sand cores among
iii. Liquid Slag
There will form some single small-size gas holes beneath the surface offoundry once the completion of machining. The diameters of holes are 1-3mm generally. Large amount of studies prove that the kind of defects also have some relation with the casting temperature. When the temperature reaches 1380℃, it’s hard to find the kind defects in gray iron foundry. It is worth mentioning that in the case of changing gating system design, it still cannot decrease the number of these defects.